General Purpose Fuse Tubing

PG-P-6001 Epoxy fiberglass filament wound general purpose fuse tubing

Product Description

PG-P-6001 designates a general "E" glass fiber reinforced composite tubing material, with an epoxy resin as matrix.

Physical Properties

Hoop Strength (Fy x 103) 60
Tensile Strength (Ft x 103 PSI) ­60
Flexural Strength, Axial (Fbx x 103 PSI) 55
Poisson’s Ratio, Axial 0.3
Shear Modulus (Gxy x 106 PSI) 0.8
Elastic Modulus (Ex x 106 PSI) 2.5
Elastic Modulus, Transverse (Ey x 106 PSI) 1.8

The above values are typical properties. These values may vary depending on a specific design.

Thermal Properties

Thermal Conductivity (BTU/hr/sq ft/°F/in) 1.8 to 2.3
Specific Heat (BTU/lb/°F) 0.27
Coefficient of Thermal Expansion (in/in/°F) 5.0 to 7 x 106
Heat Resistance, Continuous ±200°C

The above values are typical properties. These values may vary depending on a specific design.

Electrical Properties

Insulation Resistance (ohm/8" length) 2.38 x 1012
Volume Resistivity (ohm/cm) 2.41 x 1015
Surface Resistivity (ohms) 2.92 x 1015
Dielectric Strength, Short Time (volts/mil)Minimum 500
Dielectric Constant (60 cps) 4.15
Dissipation Factor (60 cps) 0.0094
Impulse (1 1/2 –40u Wave (Axial) volts/mil) 400 to 550
Power Factor at 60 cps (100v pct mx)
  As Received 5.0
  at 100°C 10.0
  After 24 hours at 100°F at 98% rel. hum. 10.0

Need parts?

Download a Design guide with parts list.

Download dielectric design guides

Disclaimer

Any ratings are typical for design purposes. Final testing and approval is the customer's responsibility for their application. This information is derived from our testing and published data. There is no assurance of these properties, or warranty provided that these products are suitable for any particular purpose or operational situation.

Polygon certifies that their product will be free from material defect. Polygon will not accept any liability for loss, damages, or costs from use or misuse of our products.

Specifications are subject to change, and may be affected by our continual process of improvement. Changes may be made without prior announcement.